Where to Start
Electric Tools
Hozo: NeoBlade Wireless Ultrasonic Cutter. I love this tool. It is an EXCELLENT tool to remove supports from. Little pricey but well worth it. I used it to reform a resin print to a different shape.
Electric Tools
Fanttik: Sander! This is such a handy tool cuz it doesnt go as hard as a dremel (top to bottom vs spin). Different sizes and different grits available so you can really clean up some rough areas you might have.
Sanding
I’ll just touch briefly on these. The right most ones are diamond files. They are really good for small detailing without risking the print. I use them a LOT for quick touch ups. The left most are your generic kinds from the large packs. They work really well if you need to focus on a section (like where supports were).
I just recently got this. I used it for gluing my nieces helm together and this stuff is REALLY good. Especially on filament. I was impressed. It is however very wet and will get EVERYWHERE if you’re not careful.
Loctite. I tend to go for the gel type as they are easier to control and seem to have a faster grab time.
This is a paint on primer. It goes on a little streaky and does take a bit longer to dry, however, I consider it my go to especially for statue/mini painting because the main goal is to just get a surface ready for paint to stick to. It’s especially handy when you don’t want to go outside to deal with a spray paint.
Army Painter: I only have a few colors of this. It’s formula is honestly unremarkable. It’s mostly full because there wasn’t anything impressive. It takes awhile to dry.
Citadel: My go to primer for any size print that I want to make. You can physically watch it dry as soon as you put it on and it lasts. It’s very durable for how fast it dries.
Surface Primer: This one is a bit of an oddity. I reserve it more for mini painting specifically because it’s a lot harder to get and is never in a bigger can than this. But it’s unmatched for mini priming. I’ve used it on my Destiny 2 Hunter Daggers because it goes on so smooth.
Note: Your base primer color can affect your paint. If you use a darker primer you’ll have to counter the darkness when you begin painting. Typically this is because mini painting requires less/watered down paint on your brush. Typically I will change between black and bone. Gray is obviously a good middle ground but I was surprised to figure out Green is a good neutral color as well.
You already likely know these primers. I’m adding them mainly in case you decide to do larger prints. These, I’m not a big fan of. However, they do okay with helping fill in layer lines and bridging the gap of how much you need to sand in order to get the surface silky smooth.
For example my Mollymauk sword used a combo of Filler primer and epoxy clay to fill in connection gaps and layer lines.