Sometimes water just doesn’t help the paint flow how you want. I use this to help. Don’t use it with water. A little will also go a long way.
Can be messy but I will swear by this stuff. It works so well. And once it’s fully dry it’s HARD to get off. I have brushes set aside specifically to use with it.
I found these powders at Hobby Lobby. These are my fave thing to finish a figure off with.
I use an older/destroyed brush and just throw this on. You can really add some good effects.
Liquitex Basic Acrylic
This stuff is amazing for textures. There are my different types but this is the one I’ve tried the most. It’s excellent for rock and statues. But it can be used for basically anything.
I use a combo of disposable brushes and my fingers.
Any type of puffy paint works. It’s really handy to add dimension to what you’re working on. Once it’s dry you can just paint over top of it if you want.
Washes aren’t required for weathering. Leather dye works just as well.
So does wood stain. I have a stack of 3 or 4 different wood stains I’ll use instead of the Army Painter Stains. Just depends on the effect you want.
I don’t use this glue for stability or putting prints together (mainly because it takes so long to dry) However. It is excellent for ooze or slime (clear tho. This is all I had on hand) You can also mix paint with it and change it’s color.
You gotta be careful because the paint can make it too wet and ruin it’s consistency. I’d say start with a drop at a time.
The Rust-oleum is not a bad way to finish off most props. It’s especially good for working prints (like the shift knobs I’ve made in the past. Still holding up). But if you’re wanting a more subtle and sun resiliant varnish I’d go with the Krylon. I havne’t fully given the Vallejo and Golden a try yet so I can’t actually say to their quality. However Golden is regarded as one of the top brands in the (non mini) painting world.
Honorable mention: If you want thick blood effects go for these ones:
Gory Red, Bloody Red, and Plasma Red.