I will swear by Behr paint. It goes on crisp and smooth and dries fantastic. Their hammered metal looks amazing and their chrome is pure mirror (I used the white and chrome on the Helm and Sword
I don’t normally use spray paints on minis or statues but I have and it’s not a bad way to get a bulk color down then add over top. The texture can be a bit hard for some paints to grab however.
These paints are specifically sold in “mini painting” areas and is what I’ve used on the hunter daggers. They are also very crisp and clean. But smaller can makes it less ideal to use on larger prints.
This brand is one of the more well known “name brand” paints for the Mini painting world.
For some reason this paint bubbles a lot for me when I add extra water to make it flow better. No idea why.
Their paint I consider about the same as Vallejo.
I will 100% swear by their washes though.
I’ve only used them a little bit. Their bottle are universally hated but their paint quality is okay.
Both of these two paints can be found at basically any craft store. I consider them just as good if not easier to work with. Their color range is amazing and they are easy to mix. I use them more than the “name brand” paints half the time.
This stuff rejects light. It’s fantastic for if you want to add very very deep shadows.
Note: You can not toss a varnish on this as even matte varnish will cause it to reflect light. (I could see this being beneficial to the underside of that helm you printed.)
I’m adding this to the paint section as it’s technically still a paint. These are the two I will swear by if you want a metallic mirror effect. I like the left one a little bit more as there’s no mixing required but Vallejo is very good and comes in basically every metallic color.
Note: a little bit goes a LONG way. Truly. I’ve used mere drops of this stuff to cover whole areas. Choose a brush that only uses this paint as it changes the texture of the brush!
I just get cheap bulk brushes at the craft stores. You can invest in more expensive/nice ones but eventually they wear out anyway so it’s up to you. When a brush starts to break down and get frizzy I’ll use them for weathering effects as a smashed up brush is the perfect amount of chaos.
You kinda need to play around with what type of brush works for what you’re painting. I found angled brushes works well for leather straps but so does small detail brushes.
I’ve also bent brushes to an angle to help get up into tight places that I other wise wouldn’t be able to reach (first brush on the left).
Some brushes get tape on them to help me know they are used for certain paints or varnishes. For example: Rub&Buff leaves an oily film on it that makes it hard to use with paint again. The brush isn’t ruined tho. Its purpose is just changed.
Best tip I have is to get a ton of different type and sizes of brushes and play around. You’ll quickly figure out what you like. And most craft stores will sell them in bulk, allowing you to try them out without committing to one at a time.